![]() Refer toAir Cleaner Assembly ReplacementorAir Cleaner Assembly Replacement. Refer toAccessory Wiring Junction Block Replacement.Route the harness in the left wheelwell forward to the left fog lamp.Connect the left fog lamp.Continue to route harness below radiator to the right fog lamp.Connect the right fog lamp.Remove the air cleaner assembly. Reinstallthe red CPA.Position the connector back in the base of the UEC.Reinstall the UEC. Insert the bare terminal in cavity C5 of connector X3. Locate the 43-way connector X3, the smaller black connector, with a red CPA towardsthe front of the UEC.A1A6B1B3C1C6D1D2E1E2F1F6G1G3H1H6 ![]() Follow the routing of the front lightingharness to the UEC. Refer toAccessory Wiring Junction Block Replacement.Route the wire harness jumper lone terminal up from the left wheelhouse area, startingforward of the washer bottle filler neck. Refer toBattery Negative Cable Disconnection and Connection.Remove the underhood electrical center (UEC), to access one of the connectors belowit. Snap the left and right fog lamp assemblies (1) to the front bumper fascia.Harness InstallDisconnect negative battery cable. Use the correct tightening sequence andspecifications when installing fasteners in order to avoid damageto parts and systems.Using the previously retained bolts (1), secure the left and right fog lamp bezelsusing the closest hole towards bezel. Thesecoatings affect fastener torque and joint clamping force and maydamage the fastener. Do not use paints, lubricants, or corrosion inhibitorson fasteners or fastener joint surfaces unless specified. Replacementfasteners must be the correct part number for that application.Fasteners requiring replacement or fasteners requiring the use ofthread locking compound or sealant are identified in the serviceprocedure. Note:Left and right bezels are not interchangeable.Ĭaution:Use the correct fastener in the correct location. Install the left and right fog lamp bezels (2) to the front fascia by engaging thesix retaining tabs. Remove the bolt (1) securing the left and right front lower outer grill panels (2).Retain bolt for future use.Release the six outer grille assembly tabs from the left and right outer lower grillepanels (2) and remove from front fascia. Remove part of the front fascia by removing the lower bolts (1). ![]() Refer toFront Wheelhouse Liner Replacement.Bezel Replacement Refer toLifting and Jacking the Vehicle.Remove the left and right front wheelhouse liners. Note:Please review the entire procedure before trying to perform it.Raise and support the vehicle. Chevrolet Equinox Service Manual / Electrical / Front Fog Lamp Package Installation
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |